ITech IT6300 Series

System Commands
Copyright© Itech Electronic Co., Ltd. 25
STATus:OPERation:INSTrument:ISUMmary1[:EVENt]?
This command can query the parameter of operation event register in channel
1. After executing this order, the register is reset.
Query syntax
STATus:OPERation:INSTrument:ISUMmary1[:EVENt]?
Arguments
None
STATus:OPERation:INSTrument:ISUMmary1:ENABle
This command can re-write the parameter of operation enable register in the
channel 1.
Command syntax
STATus:OPERation:INSTrument:ISUMmary1:ENABle
Arguments
Register parameter
Query syntax
STATus:OPERation:INSTrument:ISUMmay1:ENABle?
STATus:OPERation:INSTrument:ISUMmary1:CONDitio
n?
This command can query the parameter of operation event register in channel
1.
Query syntax
STATus:OPERation:INSTrument:ISUMmary1:CONDition?
Arguments
None
STATus:OPERation:INSTrument:ISUMmary2[:EVENt]?
This command can query the parameter of operation event register in channel
2. After executing this order, the register is reset.
Query syntax
STATus:OPERation:INSTrument:ISUMmary2[:EVENt]?
Arguments
None