ITech IT6322B

Trigger Command
Copyright© Itech Electronic Co., Ltd. 38
Chapter6 Trigger Command
TRIGger[:IMMediate]
This order is used to generate a trigger signal when trigger source is in BUS
mode. The function of this order is similar to *TRG.
Command syntax
*TRIGger[:IMMediate]
Arguments
None
TRIGger:DELay
This command is used to set the trigger delay time. When the instrument
receives the trigger signal, it will delay the set time and then start execution.
Command syntax
TRIGger:DELay {<NR1>}
Unit
S
Query syntax
TRIGer:DELay?