ITech IT6322B

Channel Combination Commands
Copyright© Itech Electronic Co., Ltd. 40
Example
INST:COM:SER CH1, CH2
Note: In this example, channel 1 and channel 2 are connected in series.
INSTrument:COMbine:SERies none
This command is used to disable the channels serial state.
Command syntax
INSTrument:COMbine:SERies none
Arguments
None
INSTrument:COMbine:PARAllel
This command is used to set the specified channels in parallel state.
Command syntax
INSTrument:COMbine:PARAllel {<NR2>}
Parameter 1
CH1|CH2|CH3
Parameter 2
CH1|CH2|CH3
Optional Parameter 3
CH1|CH2|CH3
Example
INST:COM:PARA CH1,CH2
INSTrument:COMbine:PARAllel none
This command is used to disable the channels parallel state.
Command syntax
INSTrument:COMbine:PARAllel none
Arguments
None
INSTrument:COMbine:TRAck
This command is used to set the specified channels in synchronized state.
Command syntax
INSTrument:COMbine:TRAck {<NR2>}