ITech IT6322B

Apply Commands
Copyright© Itech Electronic Co., Ltd. 44
Chapter9 Apply Commands
[SOURce:]APPLy
This command is used to switch channels and set voltage and current values at
the same time.
Parameter 1
CH1|CH2|CH3
Optional Parameter 2
Voltage|Max|Min|Def|Up|Down
Optional Parameter 3
Current|Max|Min|Def|Up|Down
Query syntax
[SOURce:]APPLy?
Example
APPL CH1,MAX,MIN
[SOURce:]APPly:VOLTage[:LEVel][:IMMediate][:AMPLi
tude]
This command sets the output voltage of three channels at the same time
without switching channels.
Parameter 1
Voltage of channel 1
Optional Parameter 2
Voltage of channel 2
Optional Parameter 3
Voltage of channel 3
Unit
V
Example
APP:VOLT 3,3,1
Query syntax
[SOURce:]APPly:VOLTage[:LEVel][:IMMediate][:AMPLitude]?