ITech IT6502D Programming Guide

SYSTem:POSetup?
Command syntax: SYSTem:POSetup?
Parameter: None
Returned parameter: RST|SAV0
SYSTem:CLEar
This command is used to clear the error information.
Command syntax: SYSTem:CLEar
Parameter: None
Returned parameter: None
SYSTem:BEEPer
This command is used to enable or disable the beeper.
Command syntax: SYSTem:BEEPer
Command syntax: SYSTem:BEEPer<bool>
Parameters:0|1|ON|OFF
Return parameters: None
inquiry command：SYSTem:BEEPer?
SYSTem:BEEPer?
Returned value 0 corresponds to the off state of beeper.
Returned value 1 corresponding to the on state of beeper.
Command syntax: SYSTem:BEEPer?
Parameters: None
Return parameters:0|1
SYSTem:COMMunicate:GPIB:RDEVice:ADDRess
This command is used to set the GPIB address.
Command syntax：SYSTem:COMMunicate:GPIB:RDEVice:ADDRess <NR1>
paramters：0-31
inquiry syntax：SYSTem:COMMunicate:GPIB:RDEVice:ADDRess?
Return parameters：<NR1>
SYSTem:INTerface
This command is used to select the communication interfaces.
Command syntax：SYSTem:INTerface <GPIB|USB|RS232 |RS485>

ITech IT6502D Specifications

General

Brand	ITech
Model	IT6502D
Category	Power Supply
Language	English