source mode.The function is the same as command *TRG.
Command syntax：TRIGger[:IMMediate]
parameter：None
relative commands：*TRG TRIG:SOURce
TRIGger:SOURce
This command is used to select the trigger source.Power supply could receive trigger signal
directly from front panel by pushing “Trigger” button or receive BUS trigger signal.
Command syntax：TRIG:SOURce <mode>
parameters：MANUAL |BUS
inquiry syntax：TRIGger:SOURce?
Return parameter：MANUAL |BUS
4.5 Output Command
[SOURce:]OUTPut[:STATe]
This command is used to control the output state of power supply.
Command syntax：[SOURce:]OUTPut [:STATe] <bool>
parameter：0|1|ON|OFF
inquiry syntax：[SOURce:]OUTPut[:STATe]?
Return parameter：0|1
[SOURce:]RISe[:LEVel]
This command is used to set the voltage rising time of power supply.
Command syntax：[SOURce:]RISe[:LEVel] <NRf>
unit：s
parameter：0~65.535
inquiry syntax：[SOURce:]RISe[:LEVel]?
Return parameter：0~65.535
To Next Page
Loading...
