To Next Page

To Previous Page

Command syntax：[SOURce:]VOLTage:PROTection:CLEar

[SOURce:]VOLTage:LIMit[:LEVel]<voltage>

This command is used to set the lower limitation of output voltage

Command syntax：[SOURce:]VOLTage:LIMit[:LEVel] <NRf>

parameter：MIN TO MAX|MIN|MAX|DEF

unit：V| mV| uV

inquiry syntax：[SOURce:]VOLTage:LIMit[:LEVel]?

Return parameter：<NRf>

[SOURce:]VOLTage:RANGe<voltage>

This command is used to set the upper limitation of output voltage

Command syntax：[SOURce:]VOLTage:RANGe <NRf>

parameter：MIN TO MAX|MIN|MAX|DEF

unit：V |mV |uV

inquiry syntax：[SOURce:]VOLTage:RANGe?

Return parameter：<NRf>

4.6 Composite Control Command

[SOURce:]APPLy {<voltage>|MIN|MAX} [,{<current> |MIN|MAX}]

This command has combined two kinds of commands----VOLTage and CURRent.As long as

the setting value is within the range of max current and max voltage,then the output voltage

and current will execute according to the present setting value.APPLy command will only be

effective when the setting values are within the range of upper limitation.If not,an execution

error will occur.MIN and MAX can also be used as special parameters.Min will enable the

output voltage and current to be 0.Max will enable the output voltage and current to be the

upper limitation value.

Command syntax：[SOURce:]APPLy <NRf>,<NRf>

parameter：MIN~MAX

unit：V, A

ITech IT6502D Programming Guide

Other manuals for ITech IT6502D