ITech IT6502D Programming Guide

[SOURce:]FALL[:LEVel]
This command is used to set the voltage falling time of power supply.
Command syntax：[SOURce:] FALL [:LEVel] <NRf>
unit：s
parameter：0~65.535
inquiry syntax：[SOURce:] FALL [:LEVel]?
Return parameter：0~65.535
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]
This command is used to set the output current value.
Command syntax：[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude] <NRf>
parameter：MIN TO MAX|MIN|MAX|DEF
unit：A |mA |uA
inquiry syntax：[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]?
parameter：None
return parameter：<NRf>
[SOURce:]CURRent[:LEVel]:TRIGgered[:AMPLitude]{<current level> | MINimum |
MAXimum }
This command is used to set a current value to be triggered.Different from general current
value,this value will be effective until it receives a trigger signal.Sending CURRent command
will not impact this command’s current setting value.Sending inquiry command will return the
original setting value.
Command syntax：[SOURce:]CURRent[:LEVel]:TRIGgered[:AMPLitude] <NRf>
parameter：MIN TO MAX|MIN|MAX|DEF
unit：A
inquiry syntax：[SOURce:]CURRent[:LEVel]:TRIGgered[:AMPLitude]?
Return parameter：<NRf>

ITech IT6502D Specifications

General

Brand	ITech
Model	IT6502D
Category	Power Supply
Language	English