ITech IT6502D Programming Guide

[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
This command is used to set the output voltage value.
Command syntax：[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude] <NRf>
parameters：MIN TO MAX|MIN|MAX|DEF
unit：V| mV| uV
inquiry syntax：[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]？
parameter：None
return parameter：<NRf>
[SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude]{<voltage level> |MINimum |
MAXimum}
This command is used to set a voltage value to be triggered.Different from general voltage
value,this value will be effective until it receives a trigger signal.Sending VOLTage command
will not impact this command’s voltage setting value. Sending inquiry command will return the
original setting value.
Command syntax：[SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude] <NRf>
parameters：MIN TO MAX|MIN|MAX|DEF
unit：V| mV| uV
inquiry syntax：[SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude]?
Return parameter：<NRf>
[SOURce:]VOLTage:PROTection[:LEVel]
This command is used to set the software-voltage protection value.
Command syntax：[SOURce:] VOLTage:PROTection[:LEVel] <NRf>
parameter：MIN TO MAX|MIN|MAX|DEF
parameters：V |mV| uV
inquiry syntax：[SOURce:] VOLTage:PROTection[:LEVel]？
Parameters:None

ITech IT6502D Specifications

General

Brand	ITech
Model	IT6502D
Category	Power Supply
Language	English