Inspection and Installation
Copyright ©ITECH Electronic Co., Ltd. 3
1.3 Connecting the Power Cord
Before connecting the power cord, please ensure the power switch of the instrument is
turned OFF. Only use the power cord supplied as a standard accessory. A summary of
connection procedures is given below.
AC power input level
Support two kinds of AC input voltage:110VAC and 220VAC.There is no need to
switch the input mode.
AC input grade:
Option Opt.01: 220VAC ± 10%, 47 to 63 Hz
Option Opt.02: 110 VAC ± 10%, 47 to 63 Hz
Categories of power cords
IT6500 series power supply provides the standard power cords as below.
Please select appropriate power cords appropriate to local voltage based on the
specifications of power cords below. If purchased model fails to meet local voltage
requirements, please contact distributor or factory for change.
To Next Page
Loading...
Need help?
General
