ITech IT6512A - Page 25

Command syntax：SYST:ERR?
Parameter:None
Returned parameter：〈NR1〉，〈SRD〉
SYSTem:VERSion?
This command is used to query the current SCPI version. The returned parameter is a string
like”YYYY.V”, in which the YYYY is the year of that version, V is the software version of that
year.
Command syntax：SYST:VERS?
Parameter:None
Returned parameter：<NRf>
SYSTem:REMote
This command is used to switch to the remote control mode(PC control).
Parameter:None
SYSTem:LOCal
This command is used to switch the instrument to local control mode(control from panel).
Command syntax：SYST:LOCal
Parameter:None
SYSTem:RWLock
This command is the same function as SYSTem:REMote，but the difference is: this
command can lock “LOCAL” button as well. When this command is executed, the “Local”
button can’t switch to local control mode.
Command syntax：SYSTem:RWLock
Parameter: None
SYSTem:POSetup
This command sets the parameters when the instrument power on.
Command syntax：SYSTem:POSetup RST|SAV0
Parameter:RST|SAV0
Returned parameter: None
Query syntax： SYSTem:POSetup?