FETCh:CURRent?
This command is used to read the current which is to be handled in the sample cache. After
sending the command and let the instrument dialogue, the readings will be sent to the
computer. This command does not affect the instrument settings. This command does not
trigger a measurement operation, requires only the latest available reading. Before reading
the new, the command returns are old readings.
Command syntax：FETCh:CURRent?
Return parameter：<NRf>
MEASure[:SCALar]:POWer[:DC]?
This command is used to enquire the actual output power.
Command syntax：MEASure[:SCALar]:POWer[:DC]?
Parameter：None
Return parameter：〈NRf〉
Return parameter’s unit：W
example：MEAS:POWer?
FETCh:POWer?
This command is used to read the power in the sample cache. After sending the command
and let the instrument dialogue, the readings will be sent to the computer. This command
does not affect the instrument settings. This command does not trigger a measurement
operation, requires only the latest available reading. Before reading the new, the command
returns are old readings.
Command syntax：FETCh:POWer?
Return parameter：<NRf>
SENSe:AVERage:COUNt
This command is used to set the number of measuring filtering.
Command syntax：SENSe:AVERage:COUNt<NR1>
parameter：0-15
inquiry syntax：SENSe:AVERage:COUNt?
To Next Page
Loading...
