ITech IT6723B - Page 30

Function and Features
Copyright © Itech Electronics Co., Ltd. 23
57600
115.2K
NONE 8BIT
NONE 8BIT
EVEN 8BIT
ODD 8BIT
USB
Select USBcommunication interface
BEEP (ON)
OFF
Disable the key sound
ON
Enable the key sound
KNOB (ON)
LOCK
Lock the rotary knob function
ON
Un-lock the rotary knob function
TRIG
(MANUAL)
MANU
Local keyboard trigger
BUS
Trigger by command
MEM
(GROUP1)
GRP1-8
Select memory group for Save and recall operation
TIMER SET
OFF
Disable the timer function
ON
Enable the timer function, time range 0.1-99999S
RESET
NO
keep the present settings
YES
restore the factory setting
EXIT
Quit the menu setting
LIST SET
LIST STATE
OFF
Set the LIST state as OFF
ON
Set the LIST state as ON
LIST LOAD
Re-load the LIST file(FILE0-FILE9)
LIST EDIT
TIME
(SEC)
SEC
Second
MIN
Minute
VSET
Set the voltage for present step
ISET
Set the current for present step
SEC
Setup single step delay time (0.1-9999)
NEXT
(YES)
YES
continue the edit of next step
NO
End up the list file edit
REPET
1-65535
Set the cycle count of list file
SAVE
NO
Un-save the current LIST file
FILE0-FILE9
Save the list file to appointed
memory
EXIT
Exit the system menu
POWER INFO
MODEL
ITXXXX
Unit model
VER
the software version
SN-1 XXXXXX
the first six number of SN
SN-2 XXXXXX
the middle six number of SN
SN-3 XXXXXX
the last six number of SN
EXIT
Exit the information menu
EXIT MENU
Exit the main menu
IT6726C power supply menu function is shown as below.
MAX VOLT
Set the max voltage output limit
OCP SET
OFF
Disable the OCP function
ON
Enable the OCP function
CHANG
MODE
ON
Enable the charge-mode function
OFF
Disable the charge-mode function
SYST SET
P-MEM
Reset
Power on parameter is restored to factory setting