ITech IT6800A Series - System:local; System:rwlock; System:beeper

SCPI Essential Order
Copyright © Itech Electronic Co., Ltd. 16
locked and can’t be used. Send or receive orders without first sending the order
to configure the remote control may cause unpredictable results.
Order syntax
SYSTem:REMote
Parameter
None
SYSTem:LOCal
This order is used to set the power supply to panel control mode through the
RS232 interface. After execute this order, all the buttons on the front panel can
be used.
Order syntax
SYSTem:LOCal
Parameter
None
SYSTem:RWLock
This order is used to set the power supply to remote control mode through the
RS232 interface, and LOCAL is not available. Executing this order will set the
power supply to remote control mode, the same result as order SYST:REM
function, the only difference is this order will lock all the buttons on the front
panel including LOCAL button (except Shift and Meter key).
Order syntax
SYSTem:RWLock
Parameter
None
SYSTem:BEEPer
This order is used to test the beeper, after execute this order, the power supply
will issue a beep sound.
Order syntax
SYSTem:BEEPer
Parameter
None
Return parameter
None