ITech IT7915-350-90 - Page 43

System-Related Functions
Copyright ©ITECH Electronic Co., Ltd. 41
External
programme
Ext
ernal analog function:
Status
Set the ON/OFF state
Mode
AM: Adjust the amplitude
Amplifier
: Monitor the real-time
output values
M
onitor phase
Select the phase to monitor.
This cannot be set in single phase
mode.
U
ratio
The external program ratio of
voltage.
I ra
tio
The external program ration of
current.
Remote sense
Set the sense function state.
Mode
Local: Local Measurement
Remote: Remote Sensing
O
n/Off phase
O
n-mode
Output on phase control
P
hase: setting the phase
Imm: immediately
O
ff-mode
Output off phase control
P
hase: setting the phase
Imm: immediately
Measurement
Set the measurement speed
S
low(500ms)
Slow mode, measuring every
500ms
Fast
(150ms)
Fast mode, measuring every
150ms
M
edium(3
00ms)
Medium mode, measuring every
300ms
General
Buzzer
Set the keyboard sound
Off
Buzzer on
On
Buzzer off
Brightness
Set the screen brightness.
1-10
Set the screen brightness level
Factory-default-
settings
Select whether to reset the factory default settings or
not.
Enter
Confirm to reset operation
Power-on setup
Set the power-on state.
Reset
When the instrument is powered
on, the instrument will initialize
some settings and [On/Off] state.
Last
When the instrument is powered
on, the instrument will remain
the same settings and [On/Off]
state as last time
you turned off the instrument.
Last
-OFF
When the instrument is powered
on, the instrument will remain
the same settings as last time you
turned off the instrument,
but the [On/Off] is OFF state.
Parallel mode
Set the instruments to parallel operation mode.
Parallel
z Master: Set the instrument to