61. Set/Enquire the current range in list mode.( C6H/C7H)
Current range (Lower bytes are in the former location, higher bytes
are in the later location)
62. Set/Enquire autotest steps.( D0H/D1H)
Autotest steps (Lower bytes are in the former location, higher bytes
are in the later location),when one step is selected,then
corresponding bit should be set to 1.
63. Set/Enquire Short steps.( D2H/D3H)
Autotest short steps (Lower bytes are in the former location, higher
bytes are in the later location),if one step is set to short on
mode,then this bit should be set to 1
64. Set/Enquire Pause steps.(D4H/D5H)
Autotest Pause steps (Lower bytes are in the former location,
higher bytes are in the later location),if one step need to pause,then
this bit should be set to 1