ITech IT8512C+ - Timing:tend:level; Timing:result

Timing Test Commands
Copyright © ITECH Electronic Co., Ltd. 62
TIMing:TEND:LEVel
This command sets the trigger level for ending the test.
Command Syntax
TIMing:TEND:LEVel <Nrf+>
Parameters
Depends on the end trigger source, which is the setting of the
Timing:TEND:SOURce command.
Examples
TIM:TEND:LEV 1
Query Syntax
TIMing:TEND:LEVel?
Returned Parameters
<NR2>
TIMing:RESult
This command is used to query Timing test results.
Command Syntax
TIMing:RESult?
Unit
S
Examples
TIM:RES?
Returned Parameters
<NR2>