ITech IT8600 Series

Measurement Functions
Copyright © ITECH Electronic Co., Ltd. 60
Description of the metering parameters:
Para
meter
Description
Para
meter
Description
Idc
Average current
Irms
Current effective value [VA]
Imax
Maximum current
Ipk+
Positive current peak value [A]
Ipk-
Negative current
peak value [A]
Udc
Average voltage [V]
Urms
Voltage effective
value [VA]
Umax
Maximum voltage
P
Active power [W]
S
Apparent power [VA]
Q
Reactive power
[var]
Pmax
Maximum power
R
Resistance
Freq
Frequency
CF
Crest factor
PF
Power factor
Uthd
Voltage total
harmonic
distortion
Time
When Timing mode is enabled, the timer
starts to count time after the load state is
ON. When Timing Mode is Off, Time has
been 0.
5.2.1 AC Mode
In AC Mode, you can apply load and measure the current input parameter of the
power supply based on CC, CR and CP Mode.
CC Mode
Press [Set] to enter the default CC Mode. Set the current value and start
loading in CC Mode. The metering interface and parameters are shown in the
following figure.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com