ITech IT8600 Series User Manual

Measurement Functions
Copyright © ITECH Electronic Co., Ltd. 62
5.2.2 DC Mode
In DC Mode, you can apply load and measure the current input parameter of
the power supply in CC, CV, CR and CP Mode.
CC Mode
Press [Set] to enter the default CC Mode. Set the current value and start
loading in CC Mode. The metering interface and parameters are shown in the
following figure.
CR Mode
Press [Set] to enter the default CR Mode. Set the resistance and start loading in
CR Mode. The metering interface and parameters are shown in the following
figure.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT8600 Series Specifications

General

Brand	ITech
Model	IT8600 Series
Category	Test Equipment
Language	English