Measure Commands
Copyright © ITECH Electronic Co., Ltd. 34
MEASure:VOLTage[:DC]?
This command initiates and executes a new voltage measurement, and returns the
measured input voltage of the electronic load.
<NR2> is the measured input voltage in volts.
MEAS:VOLT? might return 5.0011, which would be the
measured voltage across the electronic load inputs in volts.
MEASure:VOLTage:MAX?
This command initiates and executes a new maximum voltage measurement, and
returns the measured input maximum voltage of the electronic load.
<NR2> is the measured input maximum voltage in volts.
MEAS:VOLT:MAX? might return 100.0011, which
would be the measured maximum voltage across the
electronic load inputs in volts.
MEASure:VOLTage:MIN?
This command initiates and executes a new minimum voltage measurement, and
returns the measured input minimum voltage of the electronic load.
<NR2> is the measured input minimum voltage in volts.
MEAS:VOLT:MIN? might return 1.0011, which would
be the measured minimum voltage across the electronic
load inputs in volts.
MEASure:CURRent[:DC]?
This command initiates and executes a new current measurement, and returns the
measured input current of the electronic load.
To Next Page
Loading...
