iTechworld AU4i - Pre-Operation Checks; Check Oil Level Procedure; Moving Parts Safety Warning

9
Contact with moving parts
can result in serious injury
The inverter generator
contains parts which rotate
at high speed during
operation. These parts are
covered by guarding to
prevent injury.
Never operate the
inverter generator with
guarding or cover plates
removed. Avoid wearing
loose fitting clothing or
jewellery which could be
caught by moving parts.
BEFORE USING YOUR AU4i
CHECK THE OIL LEVEL
Oil/ Service/ Air Filter access panel Oil filler cap/ dipstick
1. Using the screwdriver provided loosen the 2 screws and open the oil/
service /air filter access panel.
2. Unscrew the oil filler cap/ dipstick and remove.
3. Wipe with a clean rag, without tightening the dipstick, insert it into
the oil port to check the oil level.
4. If the oil is lower than the bottom of the dipstick, add the
recommended oil.
5. Refit the oil filler cap and tighten until finger tight
6. Refit the access panel, using the screwdriver provided tighten the 2
screws.
CAUTION! Ensure your iTechworld AU4i Inverter Generator is on a flat, solid surface and
engine is turned off before using. DO NOT use on a sandy or dusty surface.