iTechworld AU4i - Starting Your AU4 i Generator; Pre-Start Checks and Connection; Starting Methods: Key and Pull Start

12
STARTING YOUR AU4i
1. Ensure the 2 white battery connectors inside the battery access panel
are connected as per the ‘Quick Setup Guide’.
2. Ensure the fuel tap is in the ‘on’ position.
Fuel tap ‘off’ position Fuel tap ‘on’ position
There are 3 ways to start your iTechworld AU4i Inverter Generator, key
start, easy recoil pull start and remote start.
Key Start: Turn the key to the ‘start’ position and hold until your
iTechworld AU4i Inverter Generator starts. Once started, release the key.
Pull Start: Pull the easy recoil starter cable until you feel resistance, then
pull quickly to start the generator.
CAUTION! Before starting your iTechworld AU4i Inverter Generator, make sure there
is no equipment connected to the AC or DC sockets. Equipment may start suddenly
when connected, causing possible injury.
NOTE: Switch the fuel tap to the ‘off’ position when the iTechworld AU4i Inverter Generator is
not in use
NOTE: The key MUST be in the ‘on’ position in order for the easy recoil pull start and to work.