15
USING THE AC POWER
Start your iTechworld AU4i Inverter Generator as per the instructions in
the ‘STARTING YOUR AU4i’ section.
Let your iTechworld AU4i Inverter Generator run for a short while. Once
the digital display shows 240v, your iTechworld AU4i Inverter Generator is
ready to be used.
Ensure your equipment is turned off before connecting to the AC outlets.
USING THE DC POWER
\
When using AC, DC can be used simultaneously.
A DC surge may cause the DC protection switch to depress. If this happens,
press the DC Protection button located on the Control Panel.
WARNING! The DC outlet is for charging 12v batteries only. Note that the battery
charging outlet IS NOT regulated. You must monitor the battery voltage. If the voltage
exceeds 14v you must immediately disconnect the battery. Failure to do so can result
in overcharge and may cause fire or explosion.
Connect the alligator clips first and then insert the ‘T’ plug into your ITechworld AU4i
Inverter Generator.
If charging a car battery, ensure the battery is disconnected from your car. DO NOT
start your car while the charging cable is connected. Doing so will damage your
iTechworld AU4i Inverter Generator.
DO NOT cross the polarity of the cables, doing so can damage your ITechworld AU4i
Inverter Generator Inverter Generator.
Ensure battery charging is done in a dry, safe, ventilated area away from fire hazards
or flammable liquids and/ or gases.
In the unlikely event battery acid comes in contact with skin or eyes, immediately go
to hospital and see a doctor.
DO NOT charge batteries near children or pets.
To Next Page
Loading...