iTechworld AU4i - Remote Start and Cautions; Remote Start Procedure; Easy Coil Starter Cable Caution

13
Remote switch ‘off’ position Remote switch ‘on’ position
Remote Start: Ensure the remote switch situated on the control panel of
your iTechworld AU4i Inverter Generator is in the ‘on’ position. On the
remote control, press the grey ‘start’ button once then immediately press
and hold until the iTechworld AU4i Inverter Generator starts.
NOTE: The remote start overrides the key start function.
NOTE: The key MUST be in the ‘on’ position in order for the remote start and to work.
Stop Button
Start Button
CAUTION! Do not let the easy coil starter cable recoil freely. Recoil the cable slowly.
Ensure you hold your iTechworld AU4i Inverter Generator tightly when pulling the
easy coil starter cable to prevent your generator tilting over.