Configuration Mode PcOS Series 150 Programmer's Guide
Page 106 Rev G 12/14/99
The serial port DTR and/or RTS signal can be configured to provide flow control. If DTR is
configured as the flow control signal, it will toggle to false when the buffer is full, RTS will not.
Options
The knife is an optional feature on the Series 150 Printer. If the hardware is installed, the
corresponding feature should be activated.
Save Changes
In self-configuration, the save changes must be set to “Yes” for any configuration changes to be
accepted. The next group selection will then save the changes and start normal operation.
To Next Page
Loading...
