Ithaca 150 - Page 44

Control Codes PcOS Series 150 Programmer's Guide
Character Attributes
Page 34 Rev G 12/14/99
Function Multiline double-wide and double-high
ASCII [ESC] W <n>
Hexadecimal 1BH 57H <n>
Decimal <27> <87> <n>
IPCL &%FD, &%FS, &%FH (Note: Single-wide, double-high print is not available
in IPCL).
EPOS [ESC] ! <n>
Description This command controls multiline double-wide or double-high mode.
Where n specifies the mode
0 begins standard single-wide and single-high &%FS
1 begins double-wide &%FD
2 begins double-high none
3 begins double-wide, double-high &%FH
Note: This command does not affect line spacing.
EPOS Note: [ESC] ! <n> performs a similar function; however, NLQ is not
available.
Where n-bits 76543210 Function
1------- Underline
--1----- Double-wide
---1---- Double-high
-------X Font: 1 = Utility, 0 = HSD
Function Set print style: double-wide, double-high, italic control
ASCII [ESC] [ @ [EOT] [NUL] <k> [NUL] <n> <m>
Hexadecimal 1BH 5BH 40H 04H 00H <k> 00H <n> <m>
Decimal <27> <91> <64> <04> <0> <k> <0> <n> <m>
IPCL &%DH Double-high, double-wide, and double-space
&%SH Single-high, single-wide, and single-space
Also, see [ESC] W.
Description This command sets double-wide, double-high, and italic print mode.
Where k-bits 76543210
----xxxx Italic control
0 ----0000 No change
1 ----0001 Italic On
2 ----0010 Italic Off
Where n-bits 76543210
----xxxx Height multiplier
0 ----0000 No change
1 ----0001 Single high
2 ----0010 Double high
xxxx---- Line spacing
0 0000---- No change
16 0001---- Single line feed
32 0010---- Double line feed
Where m-bits 76543210
----xxxx Width multiplier
0 ----0000 No change