Ithaca 150 - Page 86

Control Codes PcOS Series 150 Programmer's Guide
MICROLINE Codes
Page 76 Rev G 12/14/99
[ESC] 6 Set 6 lines per inch.
[ESC] 8 Set 8 lines per inch.
[ESC] C Start underline.
[ESC] D Stop underline.
[ESC] J Start superscript.
[ESC] M Stop superscript.
[ESC] N Start subscript.
[ESC] M Stop subscript.
[ESC] T Begin emphasized print (half speed).
[ESC] H Begin enhanced print (double pass).
[ESC] I End emphasized/enhanced print.
[ESC] K <n>
1
<n>
2
Set single-density graphics.
n1=0..255
n2=0..3
len=n1 + 256 * n2
[ESC] L <n>
1
<n>
2
Set double-density half-speed graphics.
n1=0..255
n2=0..3
len=n1 + 256 * n2
[ESC] Y <n>
1
<n>
2
Set double-density full-speed graphics.
n1=0..255
n2=0..3
len=n1 + 256 * n2
[ESC] Z <n>
1
<n>
2
Set quad-density full-speed graphics.
n1=0..255
n2=0..3
len=n1 + 256 * n2
[ESC] r <n> Set rotated print.
n=0 end
n=2 upside down
N/A Print bar code.
Interleaved 2 of 5
Code 39
Code 128
Communication Echo Mode
(Serial interface only)
[ESC] # Turn on echo mode.
[ESC] d Turn on alternate echo mode.
[ESC] “ Turn off echo mode.
[ESC] RS Turn off alternate echo mode.