REFRIGERANT DRYERS OPERATOR’S MANUAL TM357-035 & TM357-074
8. ROUTINE MAINTENANCE
BEFORE CARRYING
OUT ANY MAINTENANCE JOBS IT IS
OBLIGATORY TO STOP THE MACHINE AND DISCONNECT IT FROM
THE POWER MAINS AND FROM THE COMPRESSOR AIR
DISTRIBUTION NETWORK.
These maintenance intervals are recommended for work environments that are not dusty
and are well ventilated. For particularly dusty environments, double the frequency of
controls.
Routine
If you noticed any abnormal phenomena during routine maintenance, please stop
dryer immediately and do as stated in “Troubleshooting” section.
Checklist
No Air or Freon leaks
No alarm triggered in PDP controller
Water comes out from condensate drain
No loud noisy or smoky
Each Week
Condensate drain: Clean the filter of the steam trap
Each monthly
Condenser: Clean the condenser fins to remove eventual dust.
a. Switch off the machine
b. Remove the panels
c. Clean the condenser fins with compressed air. DO NOT USE WATER OR SOLVENTS
d. Close the panels
ALL WORK MUST BE CARRIED OUT BY PROFESSIONALLY SKILLED
PERSONNEL. BEFORE CARRYING OUT ANY MAINTENANCE JOBS
IT IS OBLIG
ATORY TO STOP THE MACHINE AND DISCONNECT IT
FROM THE POWER MAINS.
14
www.itmtools.com.au