REFRIGERANT DRYERS OPERATOR’S MANUAL TM357-035 & TM357-074
11. OPER ATIONS
11.1 STARTING
PRELIMINARY CONTROLS
Before starting the dryer, check:
a. The correct connection to the compressed air piping: remember to remove eventual
caps on the drier inlet and outlet
b. The correct connection to the condensate drainage system.
c. The power supply is right.
11.2 STARTING AND STOP
Start the system before the air compressor starts running and stop it after the air
compressor has been stopped.
WARNING: if the dryer is switched off, before starting it again, wait at least 5 minutes in
order to allow the pressure balancing.
17
www.itmtools.com.au
To Next Page
Loading...