Electromagnetic Compatibility
Caution: Use only approved accessories with this equipment. All cables must be high
quality, shielded, correctly terminated, and normally restricted to 2 meters in length.
Unapproved modifications or operation beyond or in conflict with these use
instructions may void the authority's authorization to operate the equipment.
Supported Vehicle Information
Itron's Mobile Collection systems are designed for use in land mobile vehicles such as cars,
trucks, and vans conforming to U.S. Department of Transportation standards. Use of any Mobile
Collection system in an aircraft is not supported by Itron nor certified for transmitting by the
Federal Aviation Administration and/or Transport Canada. Consult your local Aviation Authority
for additional guidance.
Warning! Do not visually monitor or physically adjust the Mobile Collection system
while driving. While driving, rely on the beeps produced when meter data is collected
to indicate proper system operation. Visually monitoring or adjusting the Mobile
Collection system while driving will divert your attention from your safe driving
responsibilities. Attention to driving is your primary responsibility, along with following
all the applicable driving regulations.
Mobile Collector Antenna Specifications
This section provides the specifications for the Mobile Collector antennas.
Caution: The Mobile Collection system is designed to operate with the antennas
listed here. Antennas not listed here are strictly prohibited for use with the Mobile
Collection system. The required antenna impedance is 50 ohms.
07 May 2020 815-0207-00 REV 000 Itron, Inc. Page 7 of 44
Vehicle Preparation and Hardware Installation Guide 1 îBefore You Begin
To Next Page
Loading...
Need help?
General
