ITW Dynatec c. 2004
DYNAMINI ASU Manual #20-25
Page 7-3
Revised 1/05
Overtemp Thermostat
The overtemp thermostat is a safety back-up. If the hopper temperature exceeds 232°C (450°F), the
thermostat causes a circuit breaker to open and power to the hopper and all hoses and heads will be
cut off. The overtemp thermostat re-sets when the hopper temperature falls below 204°C (400°F).
To re-set, turn the main power switch OFF, then ON again.
Location of Printed Circuit Boards and Overtemp Thermostat
Overtemp Thermostat
Control PC Board
PCB Board
Sensor
Heater
Overtemp Thermostat
To Next Page
Loading...