Bar graph setting③
The correspondence of each bar of the bar graph 15 pcs. for each polarity to the()
voltage can be chosen from following four kinds of setting.
LCD display : Voltage per one bar
15 : 1V
30 : 2V
150 : 10V
300 : 20V
()Default setting: 15
LCD display
5.4.2 Measurement condition setting for decay time measurement mode
When manual mode Ma is displayed, the measurement mode can be changed to()
decay time measurement mode +dE or -dE by pressing the decay time mode()
button red /+ Decay or green /- Decay .()
Positive decay time Manual mode Negative decay time
measurement mode measurement mode
LCD display
Press SET button with a thin stick. The two measurement conditions , can(① ②)
be set with the following procedure. After choosing by pressing UP/DOWN buttons,
each setting is saved in the internal memory by pressing SET button again. The(
measurement conditions are the same setting for both polarity. When all setting is)
complete, decay time measurement mode +dE or -dE is displayed again. If MODE()
button white is pressed the display will return to manual mode Ma .() ()
-page17-
To Next Page
Loading...