The measurement is continued until the setting time. Press PLATE CONTROL③
button red again to stop measuring if the setting time is continuous con .() [ ]
HOLD sign is displayed on the LCD at the end of the measurement.
During measurement Measurement end
LCD display
After the measurement, if the following buttons are pressed, each measureddata④
will be displayed.
() ( )+ DECAY button red : Maximum voltage peak value
() ( )- DECAY button green : Minimum voltage valley value
IB button yellow : Average voltage in measuring time()
Measurement end
() ( ) ( )+DECAY button red -DECAY button green IB button yellow
Maximum voltage Minimum voltage Average voltage
() ( )peak value valley value
LCD display
-page21-
To Next Page
Loading...