5101015-01 Rev 2 5
1.3 Power Unit Assembly
Top Gun can use clean dry compressed air, nitrogen or carbon
dioxide at pressures up to 100 psi. Compressed gas is connected
to a power unit that contains a solenoid to turn gas flow on and off.
High quality polyurethane tubing conducts the gas to the gun. At the
gun, flow is controlled from a whisper to a blast by an integral needle
valve using the gun control knob. The compressed gas is filtered
just prior to leaving the gun in an integrated, replaceable filter-
nozzle. The nozzle has been carefully designed to yield a forceful
blast while providing the lowest possible noise levels.
Figure 3. Top Gun Power Unit
1. Ion Balance Adjust
2. Remote Control/Footswitch/Optical Sensor Connector
3. Power Cord Connector with Fuse Drawer
4. Mounting Hole Flange
5. Compressed Air Connector
6. Top Gun Cable/Hose Connector
To Next Page
Loading...