Ivoclar digital PrograMill Base - Page 21

Initial Operation
21
Further information on unpacking your PrograMill milling machine can be found in the
operating instructions for the device (“Supporting documents”, page 7).
 Location site and workplace freely accessible
 No accessories in the PrograMill Base
 No tubes or cables on, under or in the PrograMill Base
 Pull-out shelf from the PrograMill Base dismantled (“Unpacking the PrograMill Base”,
page 18)
 Cross beam from the PrograMill Base dismantled (“Setting up the PrograMill Base”,
page 19)
1. Screw out the feet of the PrograMill
milling machine as far as possible with
an open-ended spanner.
2. Drive the fork lift underneath the
PrograMill milling machine.
3. Raise the PrograMill milling machine
from the base plate of the transport box
using the fork lift.
4. Position the PrograMill milling machine
onto the PrograMill Base using the fork
lift.