Ivoclar digital PrograMill Base - Setting Up PrograMill Accessories

Initial Operation
22
5. Position the milling machine on the
cabinet so that the feet (1) can be placed
in the indentations (2) provided on the
PrograMill Base cabinet.
6. Lower the PrograMill milling machine
onto the PrograMill Base.
7. Adjust the feet of the PrograMill milling machine to the required height using an open-
ended spanner and use a spirit level to ensure that the device is completely level.
8. Position the device so that there is no interference from other devices and so that it does
not interfere with other devices.
9. Insert the crossbeam into the PrograMill
Base (1) and screw in tightly with the
Allen screws (2).
5.3 Setting up the PrograMill accessories
The PrograMill Suction Unit and PrograMill Tank are positioned as follows. Observe the
corresponding Operating Instructions of the PrograMill Suction Unit and the PrograMill
milling machine (“Supporting documents”, page 7). When using suction systems from other
manufacturers, please refer to their manufacturer's Operating Instructions.
2
1
1.
1.
2.
2.