CHAPTER 6. OPERATION MANUAL
1
Press the MODE button to select the operation mode.
AUTO HEAT COOL DRY
2
Press the ON/OFF button to start operation.
• The red OPERATION lamp ( ) on the unit will light.
3
Press the THERMOSTAT button to set the desired tem-
perature.
AUTO/DRY MODE
• The temperature can be changed up to 2°C above or below the tem-
perature automatically determined by the air conditioner.
COOL/HEAT MODE
• The temperature can be set within the range of 18 to 32°C.
4
Press the FAN button to set the desired fan speed.
AUTO SOFT LOW HIGH
• In the DRY mode, the fan speed is preset to AUTO and cannot be
changed.
5
To turn off the unit, press the ON/OFF button again.
• The red OPERATION lamp ( ) on the unit will turn off.
BASIC OPERATION
(Example: 1°C higher)
(Example: 2°C lower)
2
5
3
1
4
TIPS ABOUT AUTO MODE
In the AUTO mode, the temperature setting and
mode are automatically selected according to
the room temperature and outdoor temperature
when the unit is turned on.
• During operation, if the outdoor temperature
changes, the temperature settings will auto-
matically slide as shown in the chart.
Modes and Temperature Settings
The gures in ( ) are temperature settings
12PHR-N_S530612PHRN.indd 1 2013/8/7 15:42:30
To Next Page
Loading...
