Factory settings
6 720 643 409 (2010/03)
92
Circuit 2,
3...(optional)
Mixing valve mode Off 1
Type of heating system
Underfloor 1
Highest permitted flow temperature T1
Radiator/Underfloor 80/45 °C 1
Lowest permitted flow temperature T1
10 °C 1
Heat curve
0
Room sensor
As Circuit 1 Heating 0, 1
Room temperature program
As Circuit 1 Heatingminus Copy to all heating
circuits
0, 1
Regulator settings
P constant
I constant
D constant
Minimum PID signal
Maximum PID signal
Mixing valve running time
Mixing valve fully closed
Mixing valve start closing
4
300
0,0
0%
100%
300s
2.0K
2.0K
1
1
1
1
1
1
1
1
Room temperature F value
Access
level
Tab. 185Factory settings Room temperature
Hot water F value
Access
level
Acknowledge hot water sensor T3 (Auto) 1
Extra hot water Extra hot water duration
Extra hot water stop temperature
0h
65 °C
0
0
Hot water peak Day of the week
Interval in weeks
Start time
Stop temperature
Maximum time
Time for warm-keeping
Wednesday
1
3:00
65.0 °C
3.0h
1.0h
0
0
0
1
1
1
Hot water program Active program
View/edit active program
Always 0
0
Hot water mode Economy 0
Hot water settings heat pump x Hot water production
Start temperature T3 economy mode
Stop temperature T8 economy mode
Start temperature T3 comfort mode
Stop temperature T8 comfort mode
Yes/No
46 °C
54 °C
56 °C
64 °C
1
1
1
1
1
Block heating during hot water demand No 0
Maximum operating time for hot water at
heating demand
30 min 0
Protective anode installed Yes/No 1
Tab. 186Factory settings Hot water
To Next Page
Loading...
Need help?
General
