SPECIFICATIONS
Pacer Pulse Rejection
Width: 0.1 to 2 ms at ±2 to ±700 mV
Overshoot: Between 4 to 100ms and not greater than 2mV.
Fast ECG signals: 2mV/100µs.
Detector disabling: None.
NOTE: Pacemaker pulses are not present in any rear panel outputs.
Alarms
High Rate: 15 to 250 bpm in 5 bpm increments
Low Rate: 10 to 245 bpm in 5 bpm increments
Asystole: R to R interval >6 seconds
Lead Off: Detached lead or offset potential >0.5 V
Simulator Option
ECG waveform amplitude: 1mV
Simulator rate: Variable rate in steps of 40, 60, 90, 120 and 150 BPM
Also manually adjustable in increments of 1 BPM.
Test Mode
ECG: 1 mV/100 ms @ 70 bpm
Display
Type: Active Matrix TFT Color LCD (640x480)
Trace: Single ECG trace with “freeze” function.
Screen Size: 13.25cm x 9.94cm, 16.5cm (6.5in) diagonal
Sweep Speed: 25, 50 mm/s
Aspect ratio: 0.4 (standard). User selectable.
Internal Floppy Drive
Type: Mitsumi D359M3D
Capacity: 1.474 MB
Size: 10.16cm W x 2.54cm H x 14.4cm D
Data Transfer: 500 k bit/sec
Media Format: IBM PC High Density.
Ethernet Module
Network Interface: RJ45 (10BASE-T)
Ethernet compatibility: Version 2.0/IEEE 802.3
Protocol: TCP/IP
Packet Rate: 250ms
ECG Data Rate: 240 samples/s
Default IP address: 10.44.22.21
Data Rates: 300bps to 115.2Kbps
Standard Temperature: 32 to 158°F (0 to 70°C)
Size: 1.574 x 1.929 in (40mm x 49mm)
Mechanical
Size: Height: 6.70in. (17.2cm)
Width: 9.25in. (33.5cm)
Depth: 9.21in. (23.4cm)
Weight: 6.5lbs (2.9kg)
Model 3000 Series Service Addendum
26
To Next Page
Loading...
Need help?
General
