iWave FDM-615PTM - Explanation of at Command in Webui

12 / 15
www.iwavecomms.com
"AT^CAMERATL"
"AT^RMTCTL"
"AT^ELFUN"
"AT^ELCH"
"AT^ELCFGUL"
"AT^RECOVSET"
"AT^APLFUN"
"AT^VCOMFUN"
"AT^DHCPSET"
"AT^DHDRSET"
3.2.Explanation of AT Command in WebUI
Explanation of AT Command in WebUI
Menu
Commands
X Value
Remark
Prompt
Debug
Switch
at+cfun=
0 or 1
Single Selection
Success or
Failure
Key
Setting
at+cfun=0
at^dapi="X"
at+cfun=1
Rule: For commands that can
only be issued in the shutdo
wn state, the combined com
mand mode must be used
"must be even num
ber"
Must be hexadecimal, i.e. 0~9, A~F
or A~F, and must not exceed 64 ch
aracters, i.e. 32 bytes. It has to be
even. Add auxiliary instructions an
d set limits
It can only be s
et after soft sh
utdown
Success or
Failure
Master-Sl
ave
Setting
at+cfun=0
at^ddtc=X
at+cfun=1
Rule: for the instruction whic
h can only be sent in the shut
down state, the combined ins
truction mode must be adopt
ed
1 or 2 or 0 can only
be displayed (1 is th
e main, 2 is the slav
e)
The single setting can only be 1/2,
but it can display 0 (X can also be 0
to indicate that the boot is of auto
matic type).
It can only be s
et after soft sh
utdown
Success or
Failure
Frequenc
y band
setting
at^daocndi=X
at+cfun=0
at+cfun=1
Prompt needs to be issued af
ter a soft restart
01 or 04 or 08
multiple choice
It can take effe
ct only after so
ft switch
Success or
Failure