4 / 15
www.iwavecomms.com
Central-Access Indicator:
The indicator will be bright (central node).
The indicator will blink (Access node).
Ethernet Indicator
After power on, it will be fast blink for self-check. When it works normally, it will blink according to
the data stream.
Signal Strength Indicator
The color of the indicator Green→Yellow→Red→Off
The change in color from green to red indicates that the signal strength goes from strong to weak.
When the light is off, which means the connection is lost.
Power Indicator
The indicator will be bright after powering on it
1.3. Notice
Please install the antennas firstly before powering on. Or the device will be burn out.
For short-distance test, distance between two units should be more than 10meters before
powering on. Otherwise, the equipment may be damaged.
The power input should be at least +24V/1.5A. Or the distance will be affected.
We suggest you to use IE browser (version 11) for Web login.
2. Software
2.1. WebUI Operation
WebUI interface operation is mainly to manually select the corresponding parameters or input
relevant parameters, configure the nodes, and return the configuration status displayed on the
UI interface.
The initial IP address is: http://192.168.1.XX
The initial user name and password are
User name: admin123
Password: admin123
Administrator login user name and password(password and user name changing is not
supported)
Administrator username: admin123
Administrator password: admin123
After registering and changing the password, it will automatically log in and jump to the index
page.
Registration function: directly enter the user name and password, the original account will be
To Next Page
Loading...