Ixon IXrouter3 IX2400 - LED Status Indicators

Cloud enable your machines
14
LED status indicators
The IXrouter3 has two LEDs for router status: one
signal LED (3G, 4G, Wi-Fi signal) and one activity LED.
The IXrouter3 requires approximately 2 minutes to
boot up and set up a secure connection.
Signal LED
Blinking blue
Initializing cellular module
Blinking red 1 pulse
No reception or unable to connect to
network
(APN or SSID may be incorrect)
Blinking red 2 pulses
PIN invalid or PUK required
(a phone is required to unlock SIM card with
PUK)
Blinking red 4 pulses
SIM card is invalid or missing
Constant red
Connected, poor reception
Constant purple
Connected, medium reception
Constant blue
Connected, good reception
Activity LED
Constant red
Booting up (may take 1-2 min) or not yet
registered
Blinking red 1 pulse
Waiting for internet access
Blinking red 3 pulses
LAN/WAN conflict
(conflicting subnets)
Blinking red 4 pulses
Removed from the platform
(re-insert USB flash drive to register again)
Blinking red 5 pulses
Previously registered to the IXplatform
(remove from the IXplatform and register
again)
Blinking blue 1 pulse
Connecting to the IXplatform
Blinking blue 2 pulse
Setting up a VPN connection
Constant blue
Active VPN connection to the IXplatform
More info
For a list of most common causes and troubleshooting tips we recommend
viewing our online article: https://support.ixon.cloud/hc/articles/360002302011