Ixon IXrouter3 IX2400 - Reset to Factory Default

Cloud enable your machines
15
Reset to factory default
Warning!
This action cannot be undone! All settings will be reset to factory default.
The IXrouter3 can be reset to the factory default settings by pressing and holding the reset
button on top for 5 seconds. The ACT LED will blink while the reset button is pressed.
Upon release of the button, the ACT LED will rapidly blink if the button was pressed long
enough to trigger a reset. Wait for the IXrouter3 to restart. You can then configure the
IXrouter3 again.
Remove previous registration
If the IXrouter3 was previously registered on the IXplatform you’ll have to
remove it from the IXplatform before you can register it again.