For Your Safe Flight ............................................. Page 11
Scanner® Information Area
The Scanner® Information Area provides expanded information in the form of
alpha-numeric messages, parameters and calculations. In Auto-Scan,
parameters will ‘scan by’ once every 4 seconds (default). This rate can be
changed in Pilot Programming Mode. Tap the STEP button for ‘Manual’ selection
of any parameter. Parameters for the installed options will be displayed. To start
the automatic scan tap LF and then STEP.
Shows successive pairs of EGT &
CHT per STEP tap.
Single Turbine Inlet Temp.
Two Turbine Inlet Temp. Left and
Right engine side
Oil temperature in degrees F
CHT cooling rate (deg/min)
Set up per the specific aircraft
Outside air temperature F or C
Hottest minus coldest EGT
Carburetor Air Temp (only allowed if
IAT not present)
Compressor Discharge Temp (only
allowed if CRB not present)
Calculated fuel remaining on board
based on what the pilot put in as
maximum.
Calculated fuel required to reach
waypoint or destination (GPS
interface must be corrected)
Calculated fuel reserve at waypoint
(GPS interface must be correct)
Nautical MILES
PER GALLON
Calculated fuel miles per units
(GPS interface required)
Calculated time remaining to fuel
exhaustion in Hours and Minutes at
present power.
Actual fuel flow rate in Gallons per
hour
Actual fuel used by the engine
To Next Page
Loading...
Need help?
General