Page 2 Engine Data Management
Table of Contents
Section 1 - Section-1 Getting Started 5
View Angle 5
Rotation 7
Fuel Flow Computer Basics (independent of fuel quantity) 7
Display Screen Basics 8
Horizontal Display Mode 8
Vertical Display Mode 9
Remote Annunciate Light Basics 9
RPM and MAP Display Basics 10
Linear Bar Graph Display Basics 10
LeanFind Basics 12
Section 2 - Interpreting Data 13
Operation for each Phase of Flight 13
Typical Normal Measurements 15
Section 3 - Displays and Controls 18
Control Buttons 18
Scanner Displays 20
Additional Displays Hobbs, Revisions, and Alarm Limits 22
Dimming the Display 23
Section 4 - Operating Modes 23
Automatic Mode 23
Manual Mode 24
Section 5 - Lean Find 26
Lean Find Procedure—General Explanation 31
Expanded Leaning Procedures 34
Common Misapplications 35
Section 6 - Fuel Flow Operation 36
Fuel Management 36
Start Up Fuel 37
Resetting ‘USD’ 38
Trip Mode (Accumulate Trip Totalizer) 38
Scanner Fuel Flow Display Select 38
Section 7 - Alarms 39
Section 8 - Memory and Data Download 40
Downloading Data from the EDM 40
Transferring data from the USB Flash Drive to a PC 41
Section 9 - First Time Setup and Customization 41
Section 10 - Adjusting Manifold Pressure & %HP 46
Adjusting the HP Constant for Rich of Peak Operation 46
Adjusting the MAP 46
Adjusting the HP Value 47
Section 11 - Programming the Fuel Flow 48
Fuel Flow K factor 48
Programming Trip Mode 51
Setting the GPS Com Format 51
To Next Page
Loading...