J.P. Instruments EDM-900 User Manual

For Your Safe Flight ............................................. Page 57
Navigation Data Formats
Output of GPS; input to EDM. The EDM automatically configures itself for
one of three industry standard data formats:
Format
Baud
NMEA-183
(Marine Nav
Data Format)
4,800
This is the format for most handheld GPS receivers. Loran
must have sentences RMA & RMB. GPS must have
sentences RMB & RMC.
Aviation Data
Format
9,600
“Output sentence type 1” Required sentences are: A, B, C,
D, E, I and L first character identifier byte. Sentence
terminator may be either <CR><LF> or <CR> alone.
Northstar
(Northstar
binary)
1,200
M1 setup select “NO EXTENDED”, “NAV ONLY”
Navigation Data Ports for GPS Comm
(These ports are independent of the EDM serial data output port.)
Navigation Data (output from GPS; input to EDM)
Compatible with RS-232, TTL, RS-423, RS-422 SDA.
Serial format: 8 data, 1 start, no parity. Baud 1200, 4800, or 9600,
depending on the GPS data output format. The EDM automatically
detects the GPS data output format and is independent of the GPS-C
setting.
Fuel Data (input to GPS; output from EDM)
RS-232 Serial format: 8 data, 1 start, no parity. Baud 9600. Output
format is determined by the GPS-C setting, but may be over-ridden
by the GPS navigation format: If the EDM senses Northstar or
NMEA-183 navigation data input, there will be no fuel data output.
Interface connections to selected GPS models
EDM P4 - Pin 1 to:
EDM P4 - Pin 2 to:
Arnav 5000
Pin 4
Pin 5
Garmin 195
(nc)
Pin 4
Garmin 430 / 430
Pin 57
Pin 56
Northstar M3P
(nc)
Pin 6 (leave pin 11 open)
UPS GX50 / 60
Pin 4
Pin 5

J.P. Instruments EDM-900 Specifications

General

Brand	J.P. Instruments
Model	EDM-900
Category	Control Panel
Language	English