For Your Safe Flight ............................................. Page 19
2
nd
Button
In Automatic or Manual modes, tapping the LF button will activate the Lean
Find mode.
In the LF mode holding the LF button after peak EGT is found will display
the peak EGT.
In Automatic or Manual modes holding the LF button for three seconds will
toggle between Standard and Normalize (NRM) views.
In the programming mode, tapping the PLUS or MINUS button will allow you
to edit a parameter value.
Holding LF during power up will display the primary alarm limits after the
self-test is complete.
1
st
and 2
nd
Buttons
Holding both the STEP and LF buttons simultaneously for five seconds will
enter the pilot programming mode.
Just after entering Lean Find Mode (but before any EGT has risen), holding
both First and Second buttons for five seconds will toggle between LOP or
ROP leaning modes.
Tapping both the STEP and LF buttons simultaneously in Manual mode
toggles to ‘include’ or ‘exclude’ the displayed non-primary measurement
from the Automatic mode only. The excluded measurement will show up in
the manual mode.
3
rd
Button
Tapping DIM (brightness decreases) or holding DIM (brightness increases)
allows decrease or increase brightness respectively.
2
nd
and 3
rd
Buttons
Holding both the LF and DIM buttons simultaneously will display the Hobbs
readings. Tap button labeled NEXT to see additional information screens.
4
th
Button ( ALL/TEMP/FUEL )
Select what is shown during Scanner auto-sequence. Choices are ALL,
TEMP or FUEL. Highlighted one is what is active.
To Next Page
Loading...