Programmable Control Panel
5
output. RS232 (2) and IR3 share the same port, the detailed use depends on the
setting of JTD-Control.
Other part is RS232 (3), it can be used for control other devices or looping output,
or connect with PC.
These two parts share the same grounding.
② This port includes: RS232 (1)/IR2, IR1 and RS485.
a) RS232 (1)/IR2: share the same port, the detailed use depends on the setting of
JTD-Control. When be used as RS232, it is unidirectional transmission,
transmit data but without receive.
b) IR1: for control other devices, it can be programmable by the JTD-Control.
c) RS485: the RS485 can be programmed as different commands and control the
device with RS485 port. The command of RS485 is the same as RS232 (1).
③ Low-Voltage relay ports: set the relay on/off by software JTD-Control
④ Power connector: 12VDC. Be sure that the “+” and “-” never be mixed or
wrong connection.
To Next Page
Loading...