jablotron Oasis - SMS Notification Setup

Oasis configuration table
No.

Oasis control panel configuration
 1.
An unsplit system (only ABC)
 2.
A system with partial setting (arming) (A or AB or ABC)
 3.
A split system (A or B or ABC)
 4.
Setting (arming) without an access code enabled
 5.
Access by code and card (both card and code have to be presented)
 6.
Exit delay beeps
 7.
Exit delay beeps while partially setting (arming)
 8.
Entrance delay beeps
 9.
Permanent alarm status display for a set system
 10.
Triggered detector indication
 11.
Auto-bypass of triggered detectors
 12.
Final-door (exit/entrance delay extended)
 13.
Device X:
 14.
Device Y:
 15.
Unsetting (disarming) by service code enabled
 20.
sec
Exit delay time
 21.
sec
Entrance delay time for a “main-door” access
 22.
sec
Entrance delay time for a “final-door” access
 A.
Automatic summer time
 B.
Programming phone numbers in maintenance mode enabled
 C.
The type of the communicator installed in the system
Notes:
• The table should be filled in by a service technician according to the system configuration
• Ticking (checking) the field in the second column indicates that the corresponding function is
enabled
ABC A B
C
A B
C

1.
Unsplit system
Only allows you to set the
entire system
 2.
Partial setting (arming)
Setting (arming) A or AB or the
entire system
 3.
Split system
Setting A or B. Section C is
automatically set if A+B
are set.
Oasis user manual 18 MKE22102