Guidelines for filling in the table:
• The table should be filled in by a service technician according to the system
configuration (composition).
• Use the ABC column to indicate which section a device falls into.
• Use the Type column for device type specification (e.g. JA-83P, JA-83M, RC-86, …).
• Use the Location/User column to describe where a detector is located (a porch, living
room,…) or to write down the user of a remote controller (Uncle Charles, Aunt Mary).
• The table can be also printed out in the Olink software.
Oasis user manual 19 MKE22102